Futaba S3003 Servo Motor 3.2 KG Torque For Arduino/Raspberry-Pi

  • Model: RCS-RC-8701
  • Shipping Weight: 150grams
  • 100 Units in Stock

Rs399.00

Add to Cart:
Futaba S3003 Servo Motor 3.2 KG Torque for Arduino/Raspberry-Pi/Robotics

The Futaba S3003 Plastic Geared Servo Motor is a decent servo for every hobbyist and electronics student. The powerful motor is PWM controlled for easy interfacing.

Features of Futaba S3003 Servo Motor 3.2 KG Torque.

Control System: +Pulse Width Control 1520usec Neutral
Required Pulse: 3-5 Volt Peak to Peak Square Wave
Operating Voltage: 4.8-6.0 Volts
Operating Temperature Range: -20 to +60 Degree C
Operating Speed (4.8V): 0.23sec/60 degrees at no load
Operating Speed (6.0V): 0.19sec/60 degrees at no load
Stall Torque (4.8V): 44 oz/in. (3.2kg.cm)
Stall Torque (6.0V): 56.8 oz/in. (4.1kg.cm)
Operating Angle: 45 Deg. one side pulse traveling 400usec
Continuous Rotation Modifiable: Yes
Direction: Counter Clockwise/Pulse Traveling 1520-1900usec
Current Drain (4.8V): 7.2mA/idle
Current Drain (6.0V): 8mA/idle
Motor Type: 3 Pole Ferrite
Potentiometer Drive: Indirect Drive
Bearing Type: Plastic Bearing
Gear Type: All Nylon Gears
Connector Wire Length: 12"
Dimensions: 1.6" x 0.8"x 1.4" (41 x 20 x 36mm)
Weight: 1.3oz. (37.2g)
Applications of Futaba S3003 Servo Motor 3.2 KG Torque.

It is used in Electronic projects.
Robotic projects using 8051/AVR/PIC/ARM/NXP/Infineon microcontroller.

This product was added to our catalog on Tuesday 04 April, 2017.

Your IP Address is: 54.166.150.10
Copyright © 2017 Robotscraft. Powered by Zen Cart